How to replace a full length riser 1 on a PowerEdge R7725

This video demonstrates the process of removing and installing a full length riser 1 on a PowerEdge R7725.

In this video we show how to replace a full length riser one in a PowerEdge R7725. Before working inside your system, read through and follow the safety guidelines to protect your system from potential damage and ensure your personal safety. For more information about safety guidelines, see the service manual at Dell.com/Support.

To remove a full length riser one, with the cover removed and secondary air shroud removed. Loosen the two captive screws in the rear. And press release latch and lift up. Then disconnect the power cable from the HPM and remove.

To install a full length riser one. Connect the power cable to the HPM. Make sure, you've got your cables routed and then slide it in. Then also route the cables again on these side clips and press down till seated. And then tighten the two captive screws on the rear. For more information or assistance about the PowerEdge R7725 visit Dell.com/Support.